|
A: Bubble counter with check valve
B:High pressure gauge, show the pressure in the cylinder
C:Adjusting knob, to control the flow rate of CO2 £¨bubble£©
D:Solenoid valve, use with a timer, to open and shut off the CO2 output automatically.
HOW TO USE
1.With cylinder valve in closed position, attached regulator to cylinder. Regulators have an inlet nipple seal(O ring gasket) that eliminates the need for a washer.
2.Add water to the bubble counter, up to 2/3 of the transparent part, bubble counter connect with the CO2 diffuser by using hose.
3.Open the solenoid valve If you regulator has it(power on).
Adjusting the knob ¡°C¡± until the required flow rate£¨bubble counting£©. |
|
|
|
A:Regulator adjusting screw, to adjust the working pressure.
B:Low pressure gauge, show the working pressure.
C:Outlet connection
D:CO2 cartridge
HOW TO USE
1.Back out regulator adjusting screw ¡°A¡± as far as it will go.
2.Attach hose to ¡°C¡±, and make sure it connected with the product container.
3.Attache CO2 cartridge to the regulator
4.Turn regulator adjusting screw slightly until required pressure. |
|
